User Forum of Software BASEMENT
| BASEMENTBasic Simulation Environment for computation of environmental flow and natural hazard simulationLaboratory of Hydraulics, Hydrology and Glaciology (VAW)ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
#1 2016-01-06 18:28:26
- sajjad
- User
- Registered: 2014-10-01
- Posts: 101
building a 1D rectangular lab flume model
I am building a 1d channel model in basechain. As the channel has a uniform slope in a x-section, i need just two points in 'node_coord' in bmg file for specifying the geometry. But I get an error ' The spacing between ground level (10) and max (dike) level (10) is smaller than the 'min_interval' you supplied'.
How to get round this problem.
Regards
Offline
#2 2016-01-06 18:33:06
- Lukas Vonwiller
- Developer
- Registered: 2014-09-04
- Posts: 127
Re: building a 1D rectangular lab flume model
Hi sajjad
Define your cross section with four points!
Hope this helps!
Lukas
Offline